Hose Measuring Guide

Assembly Length
The diagrams below Illustrate how to measure the overall length of the assembly with 
various styles and configurations of end fittings attached. Assembly lengths given to
 Raceplumbing without further definition will be produced to this convention. If you
Need further assistance please call or email your instructions to 
dan@raceplumbing.net. Custom built hoses are non returnable without approval.





Elbow Orientation

Where an assembly has an elbow or banjo fitting at both ends or a combination of

 elbows and banjos, the angular orientation between the fittings must be slated. 

This is measured in degrees anti-clockwise.The angle is measured from the center

 line of the nearest fitting when this fitting is positioned at 6 o'clock to the center

 line of the other fitting.

Note: In this example the orientation is 180°.